TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Rail Sweep tool is applying when user select 3D Spline as a Profile to sweep.
Read 643 times
September 27, 2017, 11:01:11 AM
Any other 2D or 3D for the sweep path.
(Note: Profile should only be the 2D Object)

If object isn't suitable for operation, operation will fail. There is no refinement about what object should be selected for Sweep because 2D objects and 3D curves/polylines can be used in several cases (e.g. if 3D curve/polyline is flat) as entity to sweep in tool's prompt message.

Thanks & Regards,
Zunair Attif
Manager QA\Support
IMSI Design
Email: [email protected]
Skype: [email protected]