TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

If a dimension is applied on object from Drafting Palette.
Read 183 times
September 27, 2017, 07:47:22 AM
A dimension that should be 28mm with a Zoom Factor of 2 will sometimes be displayed as 56mm.

Reason:
28 shown for associated dimension (this dimension knows it is attached to drafting with scale 2)
56 shown in not associated dimension, so this is just real distance between two points

Logged
Thanks & Regards,
Zunair Attif
QA Manager
IMSI Design
Email: [email protected]
Skype: [email protected]