TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Is there any way to insert completely MS view into PS viewport?
Read 777 times
September 27, 2017, 07:26:34 AM
Because half of the drawing is cut off and not included in default viewport on paper space? Reason behind is that the MS view is cutting by PS viewport boundary.

This sounds like a template issue. Viewports only insert a named view and if this named view by default is only half then that is what will display in the viewport.

Logged
Thanks & Regards,
Zunair Attif
Manager QA\Support
IMSI Design
Email: zattif@imsidesign.com
Skype: zattif@imsitechnologies.com