TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Trim a line against ha box ?
Read 897 times
* July 11, 2017, 01:35:28 PM
Gents, I actually don't need to! But I want :-)

The pink line I want to trim/cut or adjust to the point highlighted yellow against the 3D box.
This before the sweep operation. I know I can just slice the extra length after... BUT :-)


Logged


* July 11, 2017, 09:00:23 PM
#1
Since you already have the workplane established, I would draw a polyline (using Near snap points) along the edges of the Box. Then use that polyline to Trim your ‘pink’ line. Delete the polyline when done.

Another option might be the Line Length tool.
« Last Edit: July 11, 2017, 09:03:47 PM by John R »

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled
Windows 10, 64-bit