TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Trim a line against ha box ?
Read 463 times
* July 11, 2017, 01:35:28 PM
Gents, I actually don't need to! But I want :-)

The pink line I want to trim/cut or adjust to the point highlighted yellow against the 3D box.
This before the sweep operation. I know I can just slice the extra length after... BUT :-)


Logged


* July 11, 2017, 09:00:23 PM
#1
Since you already have the workplane established, I would draw a polyline (using Near snap points) along the edges of the Box. Then use that polyline to Trim your ‘pink’ line. Delete the polyline when done.

Another option might be the Line Length tool.
« Last Edit: July 11, 2017, 09:03:47 PM by John R »

Logged
John R.

V17—V21, 2015, 2016, 2017
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled
Windows 10, 64-bit