TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

creat symbols
Read 542 times
* May 08, 2017, 05:20:37 PM
I am drawing floor plans and create symbols in my symbol library and then can,t insert them into new drawings

Logged


* May 09, 2017, 04:37:36 AM
#1
Larryz,  is this just following a specific update or patch you have applied, or a problem that has just occurred, are you still using v21 ?, and is it deluxe or pro.

Logged


May 12, 2017, 12:16:18 AM
#2
Larryz

Please share your product details, so I can look into this.

Further here is the link for the details of inserting symbols from library into the drawing
http://www3.turbocadcommunity.com/tiki-index.php?page=Inserting+a+Symbol+from+the+Library+into+the+Drawing

Logged


* June 05, 2017, 12:17:19 AM
#3
I have a similar issue where I save lots of mechanical components in the library and then at the end of the session I save as prompted. If I then re-open the program and try to insert the component from the library it comes up as an error and deselects. The only way round this I have found is to unload the file from the library and then reload it back on. It is tedious so I try to do lots of new components in one session to minimise the aggravation. I'm sure there is an easier way but I haven't found it yet.

Logged