TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

X&Y Coordinate Points
Read 854 times
* February 18, 2017, 08:01:16 AM
When I open a drawing in dwg format the coordinate X,Y point (circle with +) is displayed. Is there a way to disable this in TC21PP so that it does not display and then can I save it without the coordinate point.

Thanks ahead for any help.
Doug
TC21ProPlat.

Logged


* February 18, 2017, 12:38:21 PM
#1
Go to "Options / Geo-Location" and turn off the "Show" Marker option.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit


* February 18, 2017, 01:56:31 PM
#2
John,

Thanks, I knew it was there to be turned off but could not figure out where it was.

Thanks again,

Doug

Logged