TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

Decoy pigeon suport
Read 809 times
* December 30, 2016, 07:49:26 AM
After breaking the circuit board on my old diy reprap, I got a new printer recently, nothing special just a Wanhao i3 (which I haven't got round to modifying yet), anyway, neighbour asked about modifying his pigeon decoy which when just put on the stick can spin 360 degrees in the wind, which is apparently not ideal, he didn't really want it glued solid, so I had a go at drawing something to restrict the movement. 

It's pretty simple and printed off OK, not perfect as I'm still getting used to the settings in the printer and cura,  unfortunately it got a bit mucky before I thought to take any pictures of it (I probably should have given it a wash first), the screws hold the part on the black stick by friction so if the stick breaks its easy to install a new stick, and my neighbour is going to paint it, probably grey.

Drawn in TC2016, adjusted ACIS edge length = 0.5, before saving a stl 

Logged


December 30, 2016, 09:00:32 AM
#1