TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


alternative nudge mode
Read 526 times
* November 08, 2016, 01:15:43 PM
An alternative nudge mode could be introduced in TC by giving the Inspector Bar's delta x,y,z boxes locks.  Most apps require an increment setup beforehand, then use arrow or numeric keys for direction, but if the IB's deltas could be locked, increments could be entered as needed.  Or code some rudimentary smarts by having an increment assumed when the lock is checked, perhaps the increment could be related to the zoom factor (larger when zoom's low, inversely smaller when zoom's high?) or overridden by entering a figure, then each nudge would be consecutive tab-and-enter.  The edit tool deltas enable this mode already, without auto increment of course, when not in selector mode.  The move tool's repeat option implies that it should work this way, too, but not in my tests.  Maybe related to translation recording, I'm thinking. 

Logged