TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Parallel Line Option
Read 564 times
July 03, 2016, 01:09:15 PM
I wish that, when creating Parallel Lines, one had the option to specify that a line with a different length be centered on the middle of the source line.

Actually, it might be even more useful if any of the SEKE Snap modes could be utilized.  I wouldn't even mind if the Offset had to be locked to make it work properly.


Jeff


Logged
TC Pro Platinum 2017, 2016 & 2015 (all with LightWorks) & V21
System: i7-5820K @ 3.30GHz, ASRock X99 Extreme4, 16GB DDR4-2133 RAM, Gigabyte GTX 970, Samsung NVMe SSD 950 (256GB), Windows 7 Pro (64-bit) SP1