TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Printing with overlap and registration marks.
Read 814 times
* January 04, 2010, 08:13:16 AM
I know that crop marks can be printed, but cropping is difficult to get perfectly on multi sheet drawings at scale size.

I place registration marks back from the edges of each sheet, which gives me an easier way to overlap (for strength) and match multi sheet drawings. To do this I set up a 1 col by 1 row page setup, print it,  and then off set the page by less than it's full width and print the next and so on.

Is there an easier way?

Thanx

Ed

Logged
Rel 20 Pro Platinum