TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

Paperspace
Read 824 times
* January 27, 2016, 11:22:28 AM
Is it possible to edit a paper space using 2015 Pro. I've looked an answer but can't seem to find it.

Logged
DonCW
2017 Pro with Light Works Plug in
2018 Platinum

Windows 10
There's so much to learn and not much time left to learn it.


* January 27, 2016, 12:28:50 PM
#1
When in a Paper Space, I usually right-click on the Printer icon or you can use "File / Page Setup".

In Model Space, go to "File / Print Queue". Double-click on the Paper Space listing to open the Print dialog. Go to "Page Setup" to make any changes. OK back to the Queue, then Print or Cancel. The changes will be retained if you Cancel.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit


* January 28, 2016, 08:28:56 AM
#2
When in a Paper Space, I usually right-click on the Printer icon or you can use "File / Page Setup".

In Model Space, go to "File / Print Queue". Double-click on the Paper Space listing to open the Print dialog. Go to "Page Setup" to make any changes. OK back to the Queue, then Print or Cancel. The changes will be retained if you Cancel.

Thanks for your reply John.
I found what I was after (it was Model Space Floating)

Logged
DonCW
2017 Pro with Light Works Plug in
2018 Platinum

Windows 10
There's so much to learn and not much time left to learn it.


* January 28, 2016, 08:57:31 AM
#3
Ah, the way to make a hole in the paper and get into the shop that way. ;D

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit