TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Remember to do a search before you ask a question!!!

"Invalid operation: Entity coordinate system is not the current coordinate syste
Read 1087 times
* December 21, 2015, 12:03:43 PM
I get this error message when trying to trim a wall from within a rectangle?  It was working before, but now its not.  What could be the difference, causing this? 

TuboCad Deluxe 2017. 
Newbie, but Getting There.

* December 21, 2015, 12:51:08 PM
Most likely the rectangle is not on the same Workplane that the bottom of the wall is.

John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled
Windows 10, 64-bit