TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Hydraulic Press
Read 2334 times
* November 12, 2015, 05:15:41 AM
Long time without participating in this forum. This is a Hydraulic Press. It was built some years ago but I decided to revisit this project and I rendered all the images in TC17.2 Pro using LW. I used the free graphics software Gimp to gather all the images in just one and to show the internal part of the oil deposit. I hope you enjoy it.


November 12, 2015, 06:41:10 AM

yes, impressive, and, thanks for posting.  8)

Regards Tim

You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2017 and TurboCAD Pro. Plat. 2016/2017/2018 + Lightworks (64-bit versions) + AnimationLab.

* November 12, 2015, 07:52:28 AM
Great job.

Henry H


* November 12, 2015, 10:04:35 AM
Excellent work.

2017 Pro with Light Works Plug in
2018 Platinum

Windows 10
There's so much to learn and not much time left to learn it.

* November 12, 2015, 05:02:09 PM
Excellent model and render, I like the paint material also as very often paint turns out too flat or too glossy and this paint job is just perfect.
« Last Edit: November 21, 2015, 02:11:16 AM by Orion20036 »


* November 13, 2015, 04:05:37 AM
Very nice work, I agree with Michael the material came out really well.

Can I ask, should the three images be different, or did you just post one and the forum software duplicated them.


* November 20, 2015, 06:51:29 AM
Hi Andy,
The three images are equal. When I tried to upload them, I was a little confused with the process as a result three images were uploaded instead of only one
I appreciate all your comments!