TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Hydraulic Press
Read 1249 times
* November 12, 2015, 05:15:41 AM
Long time without participating in this forum. This is a Hydraulic Press. It was built some years ago but I decided to revisit this project and I rendered all the images in TC17.2 Pro using LW. I used the free graphics software Gimp to gather all the images in just one and to show the internal part of the oil deposit. I hope you enjoy it.

Logged


November 12, 2015, 06:41:10 AM
#1
Hi,

yes, impressive, and, thanks for posting.  8)

Regards Tim

Logged
You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2017 and TurboCAD Pro. Plat. 2016 - 64-bit versions.


* November 12, 2015, 07:52:28 AM
#2
Great job.

Henry H

Logged


* November 12, 2015, 10:04:35 AM
#3
Excellent work.

Logged
DonCW

2017 Platinum
Light Works Plug in
Windows 10
There's so much to learn and not much time left to learn it.


* November 12, 2015, 05:02:09 PM
#4
Excellent model and render, I like the paint material also as very often paint turns out too flat or too glossy and this paint job is just perfect.
« Last Edit: November 21, 2015, 02:11:16 AM by Orion20036 »

Logged


* November 13, 2015, 04:05:37 AM
#5
Very nice work, I agree with Michael the material came out really well.

Can I ask, should the three images be different, or did you just post one and the forum software duplicated them.

Logged


* November 20, 2015, 06:51:29 AM
#6
Hi Andy,
The three images are equal. When I tried to upload them, I was a little confused with the process as a result three images were uploaded instead of only one
I appreciate all your comments!

Logged