Serial Number Issue with FM16 -- additional problem.

The Ultimate Resource for TurboCAD Knowledge

When posting a problem be sure to include which version you are using. Give as much information as possible. If the problem is with a specific file be sure to attache it to your post.

Go Down

Serial Number Issue with FM16 -- additional problem.
Read 1824 times

Next Previous

October 25, 2015, 03:05:26 PM

If I call DAEX from TC 21 it does open.

If I then open DAEX directly I must re-enter the serial numbers.

The next time I open DAEX from TC 21 I must re-enter the serial numbers again.

This pattern repeats each time I change the opening method.

It looks like this problem began in FM15 as I recall it had the same problem.

Logged

WillR
SW:TC 21 Pro Platinum, FM15, 20 Pro Platinum 64 Bit, also V 19.1 64Bit & 32 bit 17.2 and 18.1; Furniture Maker 14 and 10. HW: Vista 64 Ultimate, AMD 1090 (6 core) 8GB memory Plus also an AMD 8 core systemFX

October 26, 2015, 09:36:05 AM

It looks, that upgrade W10 cancelled registration TCFM v16. Please try to run TurboCAD like administrator and register of the TCFM again.
After open TurboCAD and please, you click on some icon TCFM in TurboCAD and register of the TCFM.

Logged

October 26, 2015, 12:11:07 PM

Did that yesterday -- but thank you for looking at the issue.

Logged

Go Up