I've been using V15 and 15.2 ever since they came out. The default location for my drawings is on a D: partition as specified in the options. This has worked fine not only for V15 but also V14 and others. However, recently when I opened TC, the opening screen for selecting a drawing was in the templates on the C: drive. The D: drive location is still specified in the program set up.
I uninstalled TC from the control panel and reinstalled. I didn't change any default file locations during the installation (I never have). After installing, I opened TC 15.2 and somehow the opening screen showed the correct location for my drawings. I opened a drawing and worked on it and then closed TC normally. Just to check that it was still working correctly, I started it back up. At the opening screen, it was now at Documents on the C: drive. Even though the program setup still showed the D: drive location, I went ahead and modified it to point to the same location. However, the opening screen still shows the Documents location.
Does anybody have an idea for correcting this behavior?