TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

RUBY... CAN MAKE AUTOLISP
Read 2601 times
* September 02, 2015, 01:45:56 PM
Hello...

I beginner Ruby, and need make Autolips as Autocad. I can make it? How to make it? or other form to make?

Thanks


Logged


* September 02, 2015, 11:32:29 PM
#1
Look at the PPM section on the forum, thats Turbocad's form of autolisp

Torfinn

Logged
V18, V19, V20, V21, 2015/ 16/ 17 Pro. Platinum
Deluxe V20, V21, 2015/ 16/ 17
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB


* September 03, 2015, 06:20:23 AM
#2
Thanks... you have the link of this PPM forum?

Logged


* September 03, 2015, 07:11:15 AM
#3
Its here, this forum, just next to the SDK corner, dont remember if it over or below SDK corner, but same area

Torfinn

Logged
V18, V19, V20, V21, 2015/ 16/ 17 Pro. Platinum
Deluxe V20, V21, 2015/ 16/ 17
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB


* September 03, 2015, 02:04:46 PM
#4

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled, except in 2018
Windows 10, 64-bit