TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

Jacob's Launcher
Read 886 times
January 04, 2015, 03:50:15 PM
This is a Launcher used today for what we (from the “50’s) would call a "top", got to get to a hobby shop again.

Logged


* January 04, 2015, 04:54:01 PM
#1
Very nice, Bob.

Henry H

Logged


* January 04, 2015, 04:55:52 PM
#2
This is a Launcher used today for what we (from the “50’s) would call a "top", got to get to a hobby shop again.
Great render Bob.

I remember the top.
Don Circa 1944

Logged
DonCW

2017 Platinum
Light Works Plug in
Windows 10
There's so much to learn and not much time left to learn it.


January 05, 2015, 05:23:46 AM
#3
Age is really an asset you know everyone wants experience, I have to quietly remind myself that - certainly when I’ll hear the term “old goat:” or “ancient” despairingly remarked. 

The lid is flexed slightly and locks in place the exterior side is flat while the other is concaved. A commercial needle bearing captures the smaller pinion gear so should run faster with ease. 

Nonetheless, does anyone use a 3D Printer Prototype Service I can send a STL file for quote? 

Logged