TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

TurboCAD Pro 14: Dimensioning a Polyline
Read 851 times
* December 09, 2013, 07:57:00 PM
I'm using TurboCAD pro to lay out a reverse spiral tubing pattern for radiant floor heat.  I have used a polyline snapped to a grid with the appropriate tubing spacing.  Since the length of each loop is important to the proper function of the system, I need a way to measure the length of the continuous polyline.  Is there a way to do this?  I was thinking that I could simply select the polyline as an entity and have it dimensioned from end to end, but I'm not finding a way to do this. 

Any suggestions would be greatly appreciated!

Thanks in advance.

Logged


* December 09, 2013, 11:10:38 PM
#1
Select the polyline and examine the metrics in the Selection pallet.
I added the individual dimensions just to illustrate the result in the metrics.

Logged
Gary Wooding
Win10 64-bit,
TC21.2 x64 Plat, Bld59
TC16.2 Plat, Bld54.0
TCC 3.5


* December 10, 2013, 12:22:13 AM
#2
I get the same as Gary; just off by a hair.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit