TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Iterating through render modes
Read 2058 times
* July 20, 2013, 02:18:55 AM
Does anybody know how to iterate through the rendering modes in VBscript, I only need to set it to wireframe, render, change it to Raytrace Full, render, and then change back again to wireframe.

The syntax for the various render modes would be handy also, but not req'd to get me started.


Any help appreciated!.

Mike Geraghty.

Logged