TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Cannot open dwg files
Read 1478 times
* October 11, 2009, 06:20:16 PM
I have dwg files that were created using TC12 Designer and some that were created using autocad, recently I upgraded to TC16 Designer, when I try to load any of those files I get a message "Failed to open[file location, blah, blah] unknown error". Is there some setting that I'm not aware of? I did a full install of TC16.