TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


18.2 Size Entries
Read 1228 times
* March 23, 2013, 07:09:43 AM
EX: When I select a cylinder and I change the X Y Z size of that cylinder, the size changes correctly but the original cylynder stays. Make Copy is not selected though that wouldn't do it anyway. I could see a good reason for this feature if you had a selection choice so maybe I have something selected that I'm not aware of.

Mike.

Logged


* March 23, 2013, 10:47:17 AM
#1
Is it possible that you really have two identical cylinders in exactly the same place to start with, and you resized just one of them? That could happen if you'd had Make Copy active at some earlier time.

Henry H

Logged


* March 23, 2013, 04:21:38 PM
#2
Ya. Probably. Couln't dupliate it. Should of thought of that. Thanks.

Logged