TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Thread Mill Demo
Read 2694 times
* December 09, 2012, 07:53:14 PM
I was doing some experimentation with the thread mill operation works pretty good.Check out few sample attachments along with a sample video.

http://www.youtube.com/watch?v=XX8a1ekwhB8

Logged
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison


December 11, 2012, 07:11:18 AM
#1
Nice demo WD. I have not tet played with this. I think I need to.

Logged
TurboCAD user since v3
 TurboCAD on flickr || My twitter ||


December 12, 2012, 07:55:58 AM
#2
Hey.

This is a very nice video.
You should make a whole video series on TurboCAD CAM, and comment with audio and also filming your CNC in action. How do I do it.
Then you certainly could sell video training too.

I spoke with someone who works in Norways largest kitchen factory, and he had tested TurboCAD CAM, and it worked just fine, and he would recommend this.

I must say that the program is positive surprises, and I think that the IMSI should get 64 bit to work as soon as possible.

Here I opened the file in TCPP19 32 bit.

By the way. I use Camtasia to make videos.
Get a 30 days trial here: http://www.techsmith.com/download/camtasia/default.asp

Kai Sannes
« Last Edit: December 12, 2012, 08:13:22 AM by KS »

Logged
Kai Sannes, DAKnor. Norwegain TurboCAD seller and instructor.
Laptop Acer Aspire VN7-793G
GeForce GTX1060, 6Gb,Core i7-7700HQ,16GB RAM,256GB PCIe SSD,1TB HDD,W10 Home
17.3" Full HD matt