TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Is there a Ruby Script for Revision Cloud?
Read 3130 times
October 10, 2012, 01:33:11 PM
Using v18.2 pro.

The default revision cloud isn't very good. The main problem is it clings to objects, even when snaps are off.

Is there a ruby script for one?


v19.2 Deluxe

November 16, 2012, 12:47:34 PM
Thanks to John, he pointed out that you can disable snaps in total by clicking "SNAP" located in the status bar at the bottom right of TurboCAD.

This solves the issue with revision clouds snapping, when "No Snap" is enabled.

If you don't see your status bar, go to Workspace/Status Bar to toggle it on. (Note: This is the location in v18.2 pro with UI Themes disabled. The location may be different with themes enabled.)

v19.2 Deluxe