TurboCAD Forums

Turbo Talk => General Discussion => Topic started by: exoticmarines on June 21, 2011, 12:57:47 PM

Title: vertical text
Post by: exoticmarines on June 21, 2011, 12:57:47 PM
Sorry if this is a repeat or a "sticky" somewhere, but how do I go about creating or manipulating text into a vertical position?  TC Deluxe 17.0
Title: Re: vertical text
Post by: wd on June 21, 2011, 01:06:36 PM
Via the inspector bar in the Rotation x,y,z in 3d Mode
Title: Re: vertical text
Post by: exoticmarines on June 21, 2011, 01:16:14 PM
Is this possible in 2D? 
Title: Re: vertical text
Post by: Julian Thomas on June 21, 2011, 01:17:13 PM
If you mean vertical orientation of letters (like MSWord WordArt) that can't be done in TC. You could hit "enter" after each letter to stack them.
Title: Re: vertical text
Post by: wd on June 21, 2011, 01:20:22 PM
Yes.Also can perform different changes in the Selection Info Palette to the text.Also rotating the text by selecting the handles
Title: Re: vertical text
Post by: exoticmarines on June 21, 2011, 01:25:45 PM
Julian - that is exactly what I meant.  Thank you for the info.