TurboCAD Forums

Turbo Talk => General Discussion => Topic started by: Huntxtrm on August 04, 2018, 02:32:12 PM

Title: Cannot see my cursor?
Post by: Huntxtrm on August 04, 2018, 02:32:12 PM
After getting a previous issue somewhat resolved.  Now I can not see my cursor.  Or, snap aperture, or preview when drawing a line?  any ideas?
Title: Re: Cannot see my cursor?
Post by: sauerkraut2018 on August 04, 2018, 08:23:31 PM
Hi,

look here: http://forums.turbocad.com/index.php/topic,23088.0.html

and

here: http://forums.turbocad.com/index.php/topic,23036.0.html
Title: Re: Cannot see my cursor?
Post by: Huntxtrm on August 11, 2018, 07:30:16 AM
Well, I sort of fixed it.  by looking at the links you provided.  I can see my cursor in wireframe now.  Still not in in any kind of render mode.  Also, render mode is not a very good quality.    It asks to turn on RedSDK when I start a drawing. My Graphics card is supported, it says.  But, if I do, the software is un-useable.  Any other ideas?  I was thinking of upgrading to 2018, but, I am having second thoughts.  Not going to upgrade to the same issues.   I have used 2017 for some time, with no issues, now this.  And, I cant figure out why.  Any ideas, suggestions would be greatly appreciated.
Title: Re: Cannot see my cursor?
Post by: Huntxtrm on August 12, 2018, 10:09:23 AM
Well, I am going to give a TC2018 a trial run before purchasing.  Hopefully, it will work better than what I have?  Not blaming the software, I am just a novice user, and having a hard time with all the perameters, I think.