TurboCAD Forums

Turbo Talk => Problems => Topic started by: BobAllevo on February 24, 2018, 04:59:13 AM

Title: Basic Training Session 3
Post by: BobAllevo on February 24, 2018, 04:59:13 AM
Hello everyone, I am new to TC Deluxe 2017 and I'm in Session 3 where I moved the workplane to the top surface. Then select large circle and move to workplane. But when I do this, the wokplane goes back to the bottom and circle doesn't move.
I can't get by this. Please help.
Thanks - Bob
Title: Re: Basic Training Session 3
Post by: Torfinn on February 24, 2018, 05:22:16 AM
Maybe you are in 2D mode, is there a 2 or 3 selector arrows when you select the circle ??

Torfinn
Title: Re: Basic Training Session 3
Post by: BobAllevo on February 24, 2018, 07:18:13 AM
Maybe you are in 2D mode, is there a 2 or 3 selector arrows when you select the circle ??

Torfinn
Thank you Torfinn, I was in 2d mode. Switching to 3d mode did it.