TurboCAD Forums

Plug-In Palace => GPS 2 TurboCAD => Topic started by: [email protected] on June 12, 2017, 02:08:38 PM

Title: GPS Data points
Post by: [email protected] on June 12, 2017, 02:08:38 PM
Just wondering if this is possible?

Ive got a garmin gps that I use for fishing and Ive used it to plot all the delivery routes in my street for my new hand truck designs. Therefore how can I get the data out of the gps and use it in gps to turbocad?

Is that possible?

Can I then use the gps data to in turbocad to demo the routes and and display the map views?

Thanks

Daz
Title: Re: GPS Data points
Post by: Jeffin90620 on June 12, 2017, 03:10:14 PM
Have you considered importing the data directly into Google Maps?


Jeff
Title: Re: GPS Data points
Post by: [email protected] on June 13, 2017, 03:21:36 AM
Jeff Ive got zero knowledge here hence the question. So what or how would google maps display gps data?

Probably better, what would I expect to see if I did that in google maps?

What Im trying to get a handle on is, can I use the data to show the most efficient route to the destination or delivery point. Eg: Plot the navigation route: travel north for 3.3 meters, turn west by 35 degrees, travel 5 meters, turn due north, travel 5 meters, turn due east. Reached delivery point.

Im trying to figure out if mapping the delivery point for a single destination makes sense and if so can that data be used by the delivery guy as an aid?

Further that if multiple data is stored for say a single street works then the benefit here is that I can demonstrate in a tangible way how the hand truck can manouvere around obstacles for a geographic area. Thereby reducing the  stress on the delivery guys body on a repetitive basis.

Thanks
Daz