TurboCAD Forums

Turbo Talk => General Discussion => Topic started by: grodgers on May 24, 2009, 01:08:57 PM

Title: Workplane by Facet
Post by: grodgers on May 24, 2009, 01:08:57 PM
Version 14.2, seemed to have lost the red highlighting of the surface being selected when using workplane by facet.

Am I missing some option selection?

Gary
Title: Re: Workplane by Facet
Post by: Henry Hubich on May 24, 2009, 03:58:06 PM
"Auto WorkPlane by Face," which highlights the facet in red (but only when an appropriate tool is selected), was not available until version 15. "WorkPlane by Facet" has been around for a long time, but it highlights the selected facet in GREEN (despite what Help sez). It's not necessary that a drawing tool be active in order to use this option.

Henry H
Title: Re: Workplane by Facet
Post by: mikeschn on May 24, 2009, 04:07:39 PM
Henry,

It's good to see you posting here... where have you been all these days... I've missed you since the old forum...

 ;)

Mike...