TurboCAD Forums

Plug-In Palace => CAM => Topic started by: wd on December 09, 2012, 07:53:14 PM

Title: Thread Mill Demo
Post by: wd on December 09, 2012, 07:53:14 PM
I was doing some experimentation with the thread mill operation works pretty good.Check out few sample attachments along with a sample video.

http://www.youtube.com/watch?v=XX8a1ekwhB8
Title: Re: Thread Mill Demo
Post by: Kenneth Martin on December 11, 2012, 07:11:18 AM
Nice demo WD. I have not tet played with this. I think I need to.
Title: Re: Thread Mill Demo
Post by: KS on December 12, 2012, 07:55:58 AM
Hey.

This is a very nice video.
You should make a whole video series on TurboCAD CAM, and comment with audio and also filming your CNC in action. How do I do it.
Then you certainly could sell video training too.

I spoke with someone who works in Norways largest kitchen factory, and he had tested TurboCAD CAM, and it worked just fine, and he would recommend this.

I must say that the program is positive surprises, and I think that the IMSI should get 64 bit to work as soon as possible.

Here I opened the file in TCPP19 32 bit.

By the way. I use Camtasia to make videos.
Get a 30 days trial here: http://www.techsmith.com/download/camtasia/default.asp

Kai Sannes