more on subscript out of range error

[Gammaman]

I have done a total reinstall of Mech 16.   simply load the attached file  insert a 3d bolt from sdk samples (its the top selection on the list)  give it a diameter of .19 a length of 2" and 1.5" of thread.  hit ok and presto! the error message subscript out of range.  Go back to sdk samples and everything is greyed out until the program is closed and restarted.

[kchapman]

Thanks for providing the values. Although I'm not getting the "everything grayed out" effect that you describe (or perhaps I'm just not recognizing it), I am getting "subscript out of range" errors when I go below a diameter of about 0.27. I'll try to find out why that's happening.

[Gammaman]

Thanks for the help. I was going nuts trying to make bolts.

Tom